Filter
Top Products
14 Printer Setup
Parking fanfold paper
It is not necessary to remove fanfold paper currently loaded in the printer in
order to print on cut-sheet paper fed by hand. Instead, simply use the following
procedure to park the fanfold paper.
❏ Tear off the paper at a perforation so there is no more than half a page
sticking out of the front cover of the printer.
If necessary, you can press the control panel’s ON LINE button to put the
printer off-line. Then use the LF button to feed the paper until a perforation
is just past the front cover.
❏ Press the control panel’s ON LINE button to put the printer on-line.
❏ Press the control panel’s LF button. The printer automatically reverse feeds
the fanfold paper until it is no longer in contact with the platen.
❏ Set the release lever on the back of the printer to the cut-sheet position.
The paper is now parked, and you can load cut-sheet paper into the printer
using the procedures under “Manual sheet feeding” on page 59.
Unparking fanfold paper
After you are finished printing on cut-sheet paper, use the following procedure
to unpark fanfold paper and make it available for printing.
❏ If any cut-sheet paper is still in the printer, put the printer on-line and then
press the control panel’s LF button to eject it.
❏ Check to make sure the printer is off-line.
❏ Set the release lever on the back of the printer to the fanfold position.
❏ Press the control panel’s LF button. The printer automatically feeds the
fanfold paper back into position, ready for printing.
Using the tear-off function
The following procedure makes it easy to tear off fanfold paper without
disturbing the current position of the paper.
❏ Check to make sure that the printer is on-line.
❏ Press the control panel’s MODE button.
The printer feeds the perforation of the fanfold paper to the tear-off edge of
the printer cover.
❏ Tear off the paper.
❏ When you resume printing, the printer reverse feeds the paper to its former
position.