Filter
Top Products
– 97 –
APPENDIX
Appendix D: General Specifications
Printing method: Serial impact dot matrix
Print direction: Bi-directional
Number of head pins: 7 wires
Number of print columns: 42 columns, 16 CPI
Character set: ASCII 96 (characters)
Special characters 64
IBM special characters 83
International characters12
Font configuration 7 (Half dots) × 7 or 9 (Half dots) × 7
Paper width 3.0 inch (76 mm)
CPI 16 13.4
Number of columns 42 35
Column spacing (mm) 1.58 1.90
Character size (mm) 1.28 × 2.87 1.59 × 2.87
Dot space (H × V mm) 0.316 × 0.423 0.316 × 0.423
Print area (mm) 66.0 66.0
Print speed: Approx. 2.5 lines per sec.
Line spacing: 1/6-inch
Paper feed method: Friction feed
Paper feed speed: Approx. 9 lines/sec.
Paper specifications
Paper type: Ordinary bond and carbonless copy paper
Paper width: 76±0.5 mm (3.0 inches)
Roll diameter: 85mm (3.35 inches) max.
Internal diameter of roll: 12±1 mm
Note: The paper must not be glued to the core.
Thickness SP210 (single) 0.07 mm to 0.10 mm
(copies) Original + 2 copies (Max. 0.2 mm)
SP240 (single) 0.07 mm to 0.10 mm
(copies) Original + 1 copies (Max. 0.1 mm)
Note:The auto-cutter built into this SP240 series prod-
uct has been designed for a maximum paper thick-
ness of 0.1 mm. This thickness is rated to a
maximum paper capacity of 2 ply paper, were
each sheet is set at 0.05 mm. Exceeding the 0.1
mm paper thickness auto-cutter specification will
not insure proper cutting.