Filter
Top Products
2-4 Netra CP32x0 SAS Storage Advanced Rear Transition Module HD User’s Guide • January 2009
2.2 Installing the ARTM-HD
The ARTM-HD must be used with a Netra ATCA node board for rear I/O access.
The ARTM-HD enables access to the network, to a boot device, and to a console
terminal.
Note – The ARTM-HD and the corresponding Netra blade server can be installed
while the shelf is powered—however, start with a powered shelf only if you must do
so.
Note – Optimally, install the ARTM-HD before installing the corresponding Netra
blade server. This order ensures proper bring up of the ARTM-HD firmware.
1. Verify that you have taken the necessary antistatic precautions.
2. Go to the back of the system and choose an appropriate slot for the ARTM-HD.
ARTMs must be installed inline behind the accompanying blade server. For
example, if the accompanying blade server is going to be installed in
slot 3, its ARTM must be installed at the back of the system in slot 3.
3. Remove the slot filler panel from the selected blade server slot, if necessary.
4. Prepare the module by loosening the locking screws and opening the
injector/ejector latch at the top of the module (
FIGURE 2-2).