Filter
Top Products
Chapter 3 Disk Management 3-9
3.10 Deleting an Array
Caution – Before deleting an array, back up all data on the array that you want to
keep.
Follow these steps to delete a selected array.
1. Select Delete Array.
2. Press Y to delete the array, or press N to abandon the deletion.
After a pause, the firmware deletes the array.
Note – Once a volume has been deleted, it cannot be recovered. When a RAID 1
volume is deleted, the data is preserved on the primary disk. The master boot
records (MBR) of other disks in the array are deleted. For other RAID types, the
master boot records of all disks are deleted.
3.11 Locating a Disk Drive
There are several ways to physically locate a disk drive, as long as the firmware is
correctly configured and the drives support disk location.
■ During RAID creation, when a disk is set to Yes as part of a RAID volume, its
Locate LED is enabled. When it is set back to No or the RAID volume is created,
the Locate LED is cleared.
■ Disks can also be located from the SAS Topology screen. To locate a disk, move
the cursor to the disk and press Enter. The Locate LED on the disk remains lit
until the next key is pressed.