Filter
Top Products
6-6
SUPERSERVER 1018D-73MTF User's Manual
Figure 6-4. Removing a Hard Drive
1
1
1
2
DVD Drive Installation
The SC113MTQ chassis may have a DVD-ROM installed (optional).
Installing or Replacing a DVD-ROM Drive (Figure 6-5)
1. Power down the system and if necessary, remove the server from the rack
and the front bezel from the chassis.
2. Remove the chassis cover.
3. Unplug the drives power and data cables from the motherboard and/or back-
plane.
4. If you are adding a new drive: Remove the mini-bezel (grate) from the drive
bay The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM, then pulling the mini-bezel forward.
If you are replacing a drive: Locate the locking tab at the rear (left hand side
when viewed from the front) of the DVD-ROM drive. Push the tab toward the
drive and push the drive unit out the front of the chassis.
5. Insert the new drive unit in the slot until the tab locks in place.
6. Reconnect the data and power cables.
7. Replace the chassis cover (replace the server in the rack, if necessary) and
power up the system.