Filter
Top Products
Scanner Emulation Interface 11 - 7
Convert All Bar Codes to Code 39
Scan a bar code below to enable or disable the conversion of all bar code data to Code 39.
Code 39 Full ASCII Conversion
By default, any characters that do not have a corresponding character in the Code 39 symbology set are
replaced by a space. If this parameter is enabled, the data sent to the Scanner Emulation host is encoded in
Code 39 Full ASCII. The host must be able to interpret Code 39 Full ASCII data.
This setting applies only if Convert to Code 39 is also enabled.
*Do Not Convert Bar Codes To Code 39
Convert All To Code 39
*Disable Convert Code 39 To Full ASCII
Enable Convert Code 39 To Full ASCII
NOTE Scanner Emulation emits an error beep and does not send any data if the scanned data
exceeds the maximum length for Code 39.