Filter
Top Products
Getting Started 1-5
4. Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the bottom of the digital
scanner.
Figure 1-4. Securing the Clamp
5. Connect the other end of the interface cable to the host (see the specific host chapter for information on host connections).
Different cables are required for different hosts. The connectors illustrated in each host chapter are examples
only. The connectors may be different than those illustrated, but the steps to connect the digital scanner
remain the same.
Removing the Interface Cable
1. Loosen the two screws on the cable clamp at the bottom of the digital scanner and gently pull the clamp away from the
bottom of the digital scanner.
2. Open the clamp and unplug the interface cable modular connector from the cable interface port on the bottom of the digital
scanner handle. Carefully slide out the cable.
3. Follow the steps for Installing the Interface Cable on page 1-4 to connect a new cable.