Filter
Top Products
1-8
LS 1000 Product Reference Guide: Chapter 1, Introduction and Setup
RS-232C (Contd)
For battery operation:
• Insert a 9-volt battery into the battery box. See
Battery Box Operation
.
• Plug the scanner's 9-pin connector at the end of the cord into one end of the
battery box.
• An output cable from the battery box connects the LS 1000 to the RS-232C
input device. Connect one end of this cable to the battery box and the other
to the appropriate port on the host device.
Figure 1-4. RS-232C Operation
coverBook Page 8 Monday, December 1, 1997 2:19 PM