Filter
Top Products
4-1
Chapter 4
Programming The LS 1004
Introduction
This chapter provides information on how to program the LS 1004 scanner. Before
programming the scanner, follow the instructions in the Appendix section of Chapter
1.
The default table, shown on the following page, illustrates the default values with
which the scanner is shipped. If the default values suit your requirements, scan the
Appendix barcode. This will set the scanner to the default parameters. Changing the
scanner’s programmable parameters is accomplished by scanning the bar codes
provided in this section.
coverBook Page 1 Monday, December 1, 1997 2:19 PM