Filter
Top Products
4-7
LS 1000 Product Reference Guide: Chapter 4, Programming the LS 1004
Power On Beep Enable/Disable
This option, if selected, causes the beeper to sound at power-up (in continuous power
mode only).
Beeper after Decode
This option determines whether the beeper sounds during normal scanning. Usually,
it is desirable to operate the unit with the beeper enabled. In all cases, the beeper
operates during parameter menu scanning and indicates error conditions. See the
Appendix 3-5 section in Chapter 3.
Beeper Tone
Three options are available for beeper tone (frequency); low, middle, and high.
Power On Beep Enable
Power On Beep Disable
Beeper Enable
Beeper Disable
Beeper Tone Low
Beeper Tone Mid
Beeper Tone High
coverBook Page 7 Monday, December 1, 1997 2:19 PM