Filter
Top Products
6. Turn on the PTC and then turn on the device it is
connected to.
7. To communicate, follow the instructions for your data
collection program.
Disconnecting a cable
CAUTION! When removing the cable from the PTC or
other device, grasp the cable connector head to remove the
cable. Pulling on the cable can break the wiring from the
cable connector.
1. Turn off the PTC-860.
2. Turn off the other computer or PTC.
3. Pull the cable’s connector directly away from the PTC’s
25-pin connector.
Do not pull at an angle.
Do not use a rocking or twisting motion when pulling the
connectors apart.
ᮣ
Cloning
Cloning is a method for sending copies of data or programs
from one PTC to another. The specific keys to press, the
sequence to follow, and the prompts that display vary according
to your application. Therefore, this procedure describes only
the general process of cloning. Refer to your individual
application documentation for specific instructions.
Before beginning the cloning procedure, be sure both PTCs are
fully charged. If either PTC turns off during the cloning
operation, you must start the procedure again. In addition, you
should monitor the cloning procedure from start to finish. At
some points, the procedure requires action from you.
The primary PTC contains the data or program to be cloned.
The secondary PTC receives the program or data.
38