Symmetricom S100 Network Card User Manual


 
S100 User Guide – Rev. D – June 2005 53
2
5
3
Chapter 4
The Web-Based Interface
Overview
The following is a description of the web-based software interface that you use to manage the
S100.
This material is designed to be a reference for you as you use the S100. It also describes
some of the procedures that will help you begin using the S100.
Symmetricom recommends you review this section before beginning the permanent
installation of the S100, so that you will be familiar with it when you need to use it.
For detailed information about NTP (Network Time Protocol), use the NTPD Help link (see
“NTPD Help” on page 84
) embedded in the S100’s web interface to review the NTP
Distribution document (source: University of Delaware).
Additional information is available at
http://www.ntp.org/.
Interface: Screen Reference
The S100 management interface has been designed with ease of use in mind. As a result,
you access the management interface S100 through any web browser. This section
describes the screens used in the interface, including their functions. It supplies some
procedural instructions, as well.
Each dialog or screen, except in the Configuration Wizard, lets you refresh that screen or
open a new window, and all will let you log out.
For security reasons, the interface will time out after 30 minutes if there is no activity.