Filter
Top Products
56 6 Troubleshooting
The Marvell Configuration Utility is also installed by running the SysKonnect installation soft-
ware from the SysKonnect CD-ROM after completing the installation of the adapter under
Windows.
Adapter does not appear in the Marvell Configu-
ration Utility
If the adapter is not listed when running the Marvell Configuration Utility, or no wireless signal
meter appears in the system tray, proceed as follows:
1. Uninstall and re-install the driver and the Marvell Configuration Utility software using the
following instructions:
• Insert the SysKonnect CD-ROM.
• Click I
NSTALL SOFTWARE on the screen that appears.
• Click N
EXT when prompted to remove the adapter.
• When removal is successful, click OK.
2. From the Control Panel, click A
DD/REMOVE PROGRAMS.
3. If the Marvell Configuration Utility is listed, highlight it and click R
EMOVE.
4. Reboot the computer.
5. Re-insert the SysKonnect CD-ROM.
6. Click I
NSTALL SOFTWARE on the screen that appears.
7. Follow the prompts to complete the installation.
See the default installation instructions for details.
Uninstalling earlier Versions of the Marvell Con-
figuration Utility
Previous versions of the Marvell Configuration Utility do not support the SysKonnect SK-54C1
Wireless LAN Cardbus Adapter. If there is a version of the Marvell Configuration Utility on
your system that was installed for some other SysKonnect product, uninstall that version be-
fore starting to install the SysKonnect Cardbus Adapter.
To uninstall the Marvell Configuration Utility, proceed as follows:
1. In the Control Panel, go to A
DD/REMOVE PROGRAMS.
2. Remove any versions of the Marvell Configuration Utility listed.
3. Install the adapter driver and the Marvell Configuration Utility according to the installation
instructions provided.
Disabling Windows Configuration Feature
Use either the Marvell Configuration Utility or the Windows Configuration Utility (in
Windows XP: the Zero Configuration Utility) to configure the wireless settings, but not both. It
is recommended that the Windows Utility be disabled and that the Marvell Configuration Utility
is used to configure the wireless adapter. If the Windows feature is enabled and the Marvell
Configuration Utility is also loaded under Windows, the Windows Utility will override the Mar-
vell Configuration Utility. The main screen of the Marvell Configuration Utility will display the
current status and signal strength information, but the profiles and any other tab of the Marvell
Configuration Utility are disabled and cannot be activated.
For information on deactivating the Windows Configuration Utility, see the Microsoft Windows
documentation.