Filter
Top Products
3. Remove the screws and open the DIMM cover by your finger.
4. Locate the memory module into the empty memory module sockets. (Your system comes
with one memory module already installed in the socket.)
• Avoid touching the exposed components inside the system. Doing so may damage the
system.
5. Insert the connector of the memory module into the socket. Make sure the notch of the
memory module fits the nose of the socket.
ü Hold the memory module at a 30-degree angle and push its connector into the
memory socket of the notebook.
ü Press down on the edge of the memory module until the locking
tabs on both sides is locked.
6. Put the DIMM door back and secure the screw on the DIMM door.
7. Turn the system over.
To remove a memory module, push the locking tabs aside from the memory module until the
module pops up. Then, remove the memory module.
7.2 Hard Disk Upgrade
Your notebook computer offers one 2.5" format, 9.5mm height hard disk. If the volume does
not fit your need or it is crashed, you can upgrade it by replacing with new hard disk. Please
do the following steps to change it.
1. Remove the screw and open the cover by lifting its upper side cover.
English
MANUAL INGLES OK 20/7/06 11:40 Página 89