TANDBERG D13202 Network Router User Manual


 
TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 12
Example of
ipqos
feedback:
*P ipqos prectlph audio auto
*P ipqos diffstlph audio 0
*P ipqos precvtlph audio auto
*P ipqos precvtlph signalling auto
*P ipqos precvtlph video auto
*P ipqos precvtlph data auto
*P ipqos diffsvtlph audio 0
*P ipqos diffsvtlph signalling 0
*P ipqos diffsvtlph video 0
*P ipqos diffsvtlph data 0
*P ipqos mode precedence
*P ipqos tos off
*P ipqos rsvp off
isdnprot
Defines various ISDN protocol settings.
isdnprot nsftel <number>
or
isdnprot nsfvid <number>
or
isdnprot sendcomplete <on/off>
or
isdnprot restart <on/off>
or
isdnprot alert <on/off>
or
isdnprot hlc <on/off>
---
sub-commands:
nsftel / nsfvid:
Selects Network Service Facility for videophony or
telephony on PRI-T1.The NSF can be configured as “” (no value) or any
number
between
0-31
to describe the service facility on your PRI-T1 line.
To enter the NSF value you must know the profile used for your line.
sendcomplete:
The Q.931 message "Sending complete" can be turned
off
.
This is only applicable for some Australian switches, which stop outgoing
calls when the message “send complete” is sent to the switch.
restart:
When restart is set to
on
the PRI interfaces will be reinitialized
after boot.
alert:
If set to
on,
the system will respond with an alert message to all
incoming setup messages. If set to
off,
the system will respond with an
alert message only to the incoming setup message related to the initial
channel.
hlc:
Turns sending of HLC information element in setup message
on
or
off
(video calls only)
.
Example of
isdnprot
feedback:
*P isdnprot nsftel ""
*P isdnprot nsfvid ""
*P isdnprot sendcomplete off
*P isdnprot restart on
*P isdnprot alert on
*P isdnprot hlct on
netprofile
Network profiles are used to predefine a set of call prefixes to be used by directory
entries.
netprofile <profile number> <call prefix> [profile name] [network]