TANDBERG D13202 Network Router User Manual


 
TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 14
prichan <PRI interface> low <1..23/31>
or
prichan <PRI interface> high <1..23/31>
or
prichan <PRI interface> search <high/low>
---
parameters:
PRI interface: a/b/c/d. Letters identifying the different PRI interfaces.
o a
: PRI interface 1
o b
: PRI interface 2
o
c
: PRI interface 3
o d: PRI interface 4
sub-commands:
max:
Sets a limit on the number of channels that will be available for
incoming and outgoing calls.
Values: 1-23 for T1 PRI, 1-30 for E1 PRI.
low:
Used together with
high
to define the line hunting strategy. The GW
will search for available channels between low and high. This allows other
devices to reserve channels outside this range
Values: 1-23 for T1 PRI, 1-31 for E1 PRI.
high:
ref. low
search:
Specifies if the search for available channels are to start from the
lower or higher limit.
Example of
prichan
feedback:
*P prichan a max 23
*P prichan a low 1
*P prichan a high 23
*P prichan a search high
pricrc4
Turns the the CRC check for PRI-E1
on/off
. CRC is default on and should stay on
in most cases.
pricrc4 [PRI interface] <on/off>
---
parameters:
PRI interface: a/b/c/d.
Letters identifying the different PRI interfaces. If
this parameter is omitted the given value is set for all interfaces.
o a
: PRI interface 1
o b
: PRI interface 2
o
c
: PRI interface 3
o d: PRI interface 4
Example of
pricrc4
feedback:
*P pricrc4 a on
*P pricrc4 b on
*P pricrc4 c on
*P pricrc4 d on
prinet
Selects ISDN PRI protocol.
prinet <protocol>
---
parameters
:
protocol: ni/att/euro.
o
ni
- National ISDN (North America)
o att
– AT&T ISDN (North America)