TANDBERG D13202 Network Router User Manual


 
TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 19
disc <gwid>
---
parameters:
gwid: 1..16. Identifier referring to a GW call.
gwdid
Sets ISDN DID (Direct Inwards Dialling) parameters. When DID is enabled the GW
will strip of the last digits in the ISDN incoming number and use this extracted
number to dial the h323 terminal. The number of digits to strip of the incoming
number and use as h323 number can be specified.
gwdid mode <on/off>
or
gwdid numbofdigits <numbofdigits>
or
gwdid maxbw <bw>
or
gwdid h323callprefix <callprefix>
---
parameters:
bw: 64/128/192/256/320/384/512/768/1152/1472/1920
sub-commands:
mode: Enables or disables DID.
numbofdigits:
Sets the number of digits to extract from the ISDN
incoming number and use as h323 number.
maxbw:
Sets the maximum bandwidth to be used when setting up a GW
call using DID.
h323callprefix:
Defines an h323 dial prefix to add to the h323 number
extracted from the incoming ISDN number.
gwextdialin
Defines the ISDN extension dial in mode and corresponding ISDN number. When
the extension dial in number is being called the GW will request an extension
number to connect to the h323 terminal.
gwextdialin [id] mode <off/ivr/ivrtcs4>
or
gwextdialin [id] isdnnumber <isdnnumber>
or
gwextdialin [id] maxbw <bw>
or
gwextdialin [id] description <description>
parameters:
id: 1
bw: 64/128/192/256/320/384/512/768/1152/1472/1920
sub-commands:
mode:
Sets the extension dial in mode to off, ivr or ivr/tcs-4.
isdnnumber:
Defines the ISDN number the GW will use as ISDN
extension dial in number.
maxbw:
Sets the maximum bandwidth to be used when setting up a GW
call using extension dial in.
description: To set an informative text.
gwh323service
Defines h323 services. H323 service prefixes are being registered at the gatekeeper.
When dialing from an h323 terminal, one of the GW’s service prefixes must be
dialed followed by the ISDN number to connect to.