Filter
Top Products
D14274.01—NOVEMBER 2008
10
T1
Administrator Guide
Contents Introduction Getting started About the menus About the settings Settings Library Cameras Appendices Contact us
Getting started
!
Cable configurations
The illustration shows the cable configurations for the Codec C90 at
rear side of the codec. The codec is located in the bottom module of
the T1 system.
Make sure the codec has been switched off and
disconnected from the line voltage whenever
connecting or disconnecting other equipment.
Mains Power
Cable
Main camera:
Video from
PrecisionHD 1080p
LAN/
Ethernet
OPTIONAL: You may connect additional microphones.
NOTE: Two extra microphones included.
65” LCD Monitor
Audio module
(DNAM)
OPTIONAL:
Audio from PC
Video
from PC
OPTIONAL: You may connect a second camera.
NOTE: Extra camera is not included.
Extra camera will require separate power supply
and control cabling. Consult the documentation
supplied with the extra camera for details.
Main camera:
Camera Control to
PrecisionHD 1080p
Microphone