Filter
Top Products
D14274.01—NOVEMBER 2008
53
T1
Administrator Guide
Contents Introduction Getting started About the menus About the settings Settings Library Cameras Appendices Contact us
Appendices
TANDBERG DNAM
The TANDBERG DNAM – Digital Natural Audio
Module – is built on two specially designed
and separate modules, the amplifier and the
loudspeaker cabinet.
The DNAM Loudspeaker Cabinet
3-way Center Speaker system•
Frequency range 50Hz - 20kHz•
2 x 100mm low- and midrange loudspeakers, •
8 ohms nominal, excellent quality (SEAS Excel
series)
1 x 25mm dome tweeter, 6 ohms nominal, high •
quality
Crossover filtered audio signals received from •
DNAM amplifier
Long time max power 70 Watt on all •
loudspeakers
Enclosed MDF speaker cabinet•
Integrated Stereo Speaker
2-way Stereo Speaker System, each side has:
1 x 100mm low- and midrange loudspeaker, 8 •
ohms nominal, excellent quality (SEAS Excel
series)
1 x 25mm dome tweeter, 6 ohms nominal, high •
quality
Passive crossover filter•
Frequency range 70 Hz - 20 kHz•
Long time max power 70 Watt•
Enclosed MDF speaker cabinet•
RCA (audio in)
RCA (loop out)
XLR–female
XLR–male
15 pin D-SUB
(for loudspeakers)
Power socket
The DNAM Amplifier
3 x 50W continuous average Center Output •
Power (load specified by DNAM Center
Speakers).
2 x 50W continuous average Stereo Output •
Power (load specified by TANDBERG
Loudspeaker Stereo Kit).
Full dynamic range for audio (high fidelity range) •
or Integrated stereo speakers.
Digital Signal Processing and Filtering on all •
channels for best audio detail clarity.
Digital Crossover Filtering on center channels.•
In/out:•
Audio In - SPDIF (stereo) or Analog (mono), •
using the same connector.
Differential In - (female XLR pinout: 1 - GND, •
2 – Signal (+), 3 – Signal (-))
Loop Out - line out directly from the input, •
always analog even with SPDIF in.
Stereo Out - (male XLR, common GND •
configuration)
Fuse 2A 250V Slow, 5 x 20mm, Littelfuse type •
215002.
DNAM Amplifier
DNAM Loudspeaker
Fuses