Filter
Top Products
AT Commands
Table A-4. Cellular CDMA Commands
AT Command Parameter Description
~NAMLCK Stores the pass-code number provided by the service
provider when service is activated. Returns OK if number is
acceptable. The default is AT~NAMLCK=000000.
~NAMVAL?0 Query the stored account information in the transceiver
~NAMVAL=
<nam>,<nu
m>,
<sid>,<nid
>
Sets the active account index. The OMEGA CDMA Modem
supports two accounts. Using only the <nam> parameter (0
or 1) sets that account as the active account used by the
modem.
Write Account Activation Data
This form requires the optional parameters. The modem
first compares the pass-code stored using ~NAMLCK. If
the pass-code fails to match, an ERROR result code is
returned. If the OK result code is returned, the NAM profile
account was activated successfully.
Parameters values are:
NAM: < 0 or 1 >
NUM: < 10 digit phone number, including area code >
SID: < up to 6 digits >
NID: < leave blank or up to 6 digits >
The service provider will tell you which numbers to enter
for <num>, <sid>. And <nid>. The choice of account
(NAM) is up to you. After writing the values, reset the
modem to have the values take effect.
Table A-5. QUALCOMM-Proprietary Commands
AT Command Parameter Description
$QCQNC= <value> Packet call behavior
$QCVAD= <value> Pre-arrangement setting
Table A-6. Telenetics-Proprietary Commands
AT Command Parameter Description
*R= <value> Set period, in seconds, for re-registration.
*R? Show re-re
g
istration
p
eriod.
Page 24