Filter
Top Products
8-51
Processing Components - Limiter
increase or decrease is controlled by the fine/coarse control.
Attack, Window, Release, and Crest factor controls.
All of these controls can be adjusted in three ways:
Using the Knob
Click on the indicator on the knob and while continuing to hold
down the mouse button, move the mouse in an arc. The
numbers in the box below the knob will change. When the
desired level is reached, release the mouse button.
Using the Text Box
Click in the box. Using the Back Space and/or Delete keys
erases the current entry and enters the new level. Be sure to
press the Enter key after the entry is made. Clicking outside the
text box without pressing the Enter key will cause the setting to
return to the number that it was before a change was attempted.
Alternatively, click and drag across the number in the box to
highlight the number in it. Type the new setting and press the
Enter key when finished.
Using the UP/DOWN Arrows
To increase the level, click on the up arrow. To decrease the
level attenuation, click on the down arrow. The amount of
increase or decrease is controlled by the fine/coarse control.
Fine or Coarse Control
This button determines the increment/decrement associated with the
UP/DOWN arrows. Fine produces small steps in value, while Coarse
provides large steps in value. Clicking on the button will toggle the
setting.
Knee Control
This button determines the type of transition that occurs when the
component goes from inactive to active. A Hard knee causes the
response by the component to be abrupt, while a Soft knee causes a
gentle response. Clicking on the button will toggle the setting.
Bypass Control (master)
This button determines if the component is in the processing chain. If
the LED on the button is gray, then the component is inserted into
the signal processing chain. If the LED is red, then the component is
bypassed in the signal processing chain. A bypassed component will
be colored red in the QuickMAP.