Filter
Top Products
Introduction to the HPI
www.ti.com
Table 2. HPI Signals (continued)
Signal State
(1)
Host Connection Description
HCNTL[1:0] I Address or control pins The HPI latches the logic levels of these pins on the
falling edge of HAS or internal HSTRB (for details
about internal HSTRB, see Section 3.3). The four
binary states of these pins determine the access type
of the current transfer (HPIC, HPID with
autoincrementing, HPIA, or HPID without
autoincrementing).
HR/W I R/W strobe pin HPI read/write. On the falling edge of HAS or internal
HSTRB, HR/W indicates whether the current access is
to be a read or write operation. Driving HR/W high
indicates the transfer is a read from the HPI, while
driving HR/W low indicates a write to the HPI.
HHWIL I Address or control pins Halfword identification control input. This bit identifies
the first and second halfwords of a dual halfword cycle
operation. HHWIL=0 identifies the first cycle and
HHWIL=1 identifies the second cycle. HHWIL applies
only to HPI16 mode and not to HPI32 mode.
HAS I ALE (address latch enable) or Address strobe. A host with a multiplexed address/data
address strobe pin bus can have HAS connected to its ALE pin. The
falling edge of HAS latches the logic levels of the
HR/W, HCNTL1, and HCNTL0 pins, which are typically
connected to host address lines. When used, the HAS
signal must precede the falling edge of the internal
HSTRB signal.
HD[31:0] I/O/Z Data bus The HPI data bus carries the data to/from the HPI.
HD[15:0] HD[31:0] applies to HPI32 and HD[15:0] applies to
HPI16.
HRDY O/Z Asynchronous ready pin When the HPI drives HRDY low, the host has
permission to complete the current host cycle. When
the HPI drives HRDY high, the HPI is not ready for the
current host cycle to complete.
HINT O/Z Interrupt pin The DSP can interrupt the host processor by writing a
1 to the HINT bit of HPIC. Before subsequent HINT
interrupts can occur, the host must clear previous
interrupts by writing a 1 to the HINT bit. This pin is
active-low and inverted from the HINT bit value in
HPIC.
10
Host Port Interface (HPI) SPRUGK7A–March 2009–Revised July 2010
Copyright © 2009–2010, Texas Instruments Incorporated