Filter
Top Products
E-DOC-CTC-20080421-0010 v1.0
8
1 Installation
1.2.2 Manual Installation
Procedure
Proceed as follows:
1 Connect the cables
2 Configure the Thomson Gateway
Connect the cables
Proceed as follows:
1 Connect your computer to the Thomson Gateway as described in “3 Adding a New Computer to your
Network” on page 19.
2 Connect the Thomson Gateway to the DSL line.
3 Connect the power supply.
4 Turn on the Thomson Gateway.
Configure the Thomson Gateway
1 Open your web browser.
2 The Thomson Gateway informs you that you have not yet configured your Thomson Gateway.
If this window does not appear browse to http://dsldevice.lan
or to the IP address of your Thomson
Gateway (by default: 192.168.1.254
) and click Thomson Gateway on the menu on the left-hand side.
3 Click Setup my Thomson Gateway.
4 The Easy Setup wizard appears. This wizard will guide you through the configuration of your Thomson
Gateway. Click Next and follow the instructions.
If your Internet Service Provider (ISP) is not using the Thomson Gateway to access the Internet,
you must not connect the DSL cable. Instead, use an Ethernet cable to connect the WAN port of
your Thomson Gateway to your Internet Gateway.