Filter
Top Products
4 Replacement Procedures
4-64 Minnesota 10A/10AG Series Maintenance Manual
Installing the VGA Board
To install the VGA board, follow the steps below and refer to the figure in the preceding
section:
CAUTION: If you remove the heat sink, use the grease tool (ex. stain remover) to remove
the grease on the VGA board and heat sink. Reapply fresh grease before installing the heat
sink.
1. Place the VGA board in the chassis and secure with four M2.5x4 screws.
2. Seat the VGA heat sink on top of the VGA board.
3. Secure the VGA heat sink to the VGA board with four spring screws. Follow the order
indicated by the numbers on the heat sink to secure the screws.