Toshiba A30 Laptop User Manual


 
Power and Power-Up Modes
Satellite A30 Series 6-10
Satellite A30 Series
Version
1
Last Saved on 12/08/2003 14:15
ENGLISH using Euro_M.dot –– Printed on 12/08/2003 as IM_A30EN
In such case, follow the steps below.
1. Fully discharge the battery by leaving it in the computer with the
power on until the power automatically shuts off.
2. Plug in the AC adaptor.
3. Charge the battery until the Battery indicator glows green.
Repeat these steps two or three times until the battery recovers normal
capacity.
Leaving the AC adaptor connected will shorten battery life. At least once
a month, run the computer on battery power until the battery is fully
discharged, then recharge the battery.
Monitoring battery capacity
Remaining battery power can be monitored by the TOSHIBA Power
Management Utility. Refer to Utilities in Chapter 1, Introduction.
Wait for a moment after turning on the computer before trying to monitor
the remaining operating time. The computer needs this time to check the
battery’s remaining capacity.
With repeated discharges and recharges, the battery’s capacity will
gradually decrease. Therefore, an often used, older battery will not
operate for as long as a new battery even when both are fully charged.
Maximizing battery operating time
A battery’s usefulness depends on how long it can supply power on a
single charge.
How long the charge lasts in a battery depends on:
How you configure the computer (for example, whether you enable
battery power saving options). The computer provides a battery save
mode to conserve battery power. This mode has the following
options:
Display auto off
HDD auto off
System auto off
LCD brightness
How often and how long you use the hard disk, CD-ROM and the
diskette drive.
How much charge the battery contained to begin with.
How you use optional devices, such as a PC Card, to which the
battery supplies power.
Enabling Resume mode conserves battery power if you are frequently
turning the computer off and on.
Where you store your programs and data.