Filter
Top Products
User's Manual
8-10
OPTIONAL DEVICES
10. Seat the insulation sheet to cover the module.
NOTE: Be sure to check that the insulation sheet is returned to the
original position to cover the memory module.
11. Insert tabs on the front of the keyboard into corresponding notches on the
computer and seat the keyboard.
CAUTION: When seating the keyboard, be sure to fit the flexible printed
circuit board under the palm rest if the flat cable was pulled out while
you were removing the keyboard.
12. Two screws secure the keyboard and one screw secures the metal brace.
CAUTION: Be sure to use all two screws removed in step 6. Make sure
no screw was dropped into the computer. Make sure all foreign matter,
such as the tape applied in step 9 is removed.
13. Seat the keyboard brace and press to secure latches.
14. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes, for details.
15. Turn the power on and make sure the added memory is recognized. Open
System Properties in the Control Panel and click the General tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode then:
1. Turn the computer off and remove all cables connected to the computer.
2. Turn the computer upside down and remove the battery pack (refer to Chapter
6, Power and Power-Up Modes.)
3. Slide the display latch on the front of the computer to the right and open the
display panel.
4. Follow steps 5 through 8 in Installing memory module to access the memory
module.
5. Push the latches to the outside to release the module. A spring will force one
end of the module up.
6. Grasp the sides of the module and pull it out, then replace the insulator.