Filter
Top Products
APPENDIX 4 SYSTEM MODE
EO1-33029
A4.4 Printer Parameter Fine Adjustment
A4-11
A4.4 Printer Parameter
Fine Adjustment
(Cont.)
Ribbon Motor Voltage Fine Adjustment (Feed/Rewind Motor)
With this parameter you can fine adjust the Ribbon Motor Voltage
(Torque). When “<3>ADJUST SET” appears, press the
[PAUSE]
key
7 times to enter the Ribbon Motor Voltage Fine Adjustment (Rewind
Motor) menu.
To change the screen to the Ribbon Motor Voltage Fine Adjustment
(Feed Motor), press the
[PAUSE]
key again.
[FEED]
key: Pressing the
[FEED]
key one time causes a –1 step change,
up to –15 steps.
[RESTART]
key: Pressing the
[RESTART]
key one time causes a +1
tone change, up to +0 steps (Rewind Motor) or +10 steps (Feed Motor).
After completing the fine adjustment, press the
[PAUSE]
key.
NOTES:
• The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter. The maximum
ribbon motor voltage fine
adjustment value is
−
15(Rewind Motor) or +10
and –15 (Feed Motor).
When the value reaches the
maximum, the value
remains unchanged even if
the subsequent fine
adjustment is performed.
• One step corresponds to 5%
of the standard voltage and
up to 75% of the voltage
can be decreased. Only for
the feed motor, the voltage
can be increased up to 50%.
• Please make this adjustment
if a ribbon error occurs
though the ribbon is not
jammed nor depleted.
If the problem cannot be
resolved, please contact
your nearest TOSHIBA TEC
service representative.
5%1$'-%.!
[RESTART]
[FEED]
5%1$'-):!
5%1$'-):!
5%1$'-):!
5%1$'-):!
5%1$'-):!
5%1$'-):!
5%1$'-%.!
5%1$'-%.!
5%1$'-%.!
5%1$'-%.!
5%1$'-%.!
Rewind Motor Feed Motor
Rewind Motor
Feed Motor