Filter
Top Products
2. MAJOR UNIT REPLACEMENT
EO18-33018
2.6 Replacing the Head Up Sensor, Slit Sensor (Rewind/Feed) and Ribbon Motor (Rewind/Feed)
2-13
NOTES:
1. After replacing the ribbon motor, refer to Section System Mode Manual to perform a Maintenance
Counter clear.
2. Secure the ribbon motors while inserting a 0.1 mm-thick paper (or folded backing paper) between
the ribbon motor pulley and the idler gear to adjust the backlash. After the ribbon motors is
secured, remove the paper.
4) Perform a test print to print to confirm that the printer works properly.
Ribbon Motor Pulley (Rewind)
Ribbon Moto
r
Pulley (Feed)
Idler Gea
r
Idler Gear