Filter
Top Products
2. MAJOR UNIT REPLACEMENT
EO18-33018
2.8 REPLACING THE MEDIA SENSOR
2-18
NOTES: 1. When reassembling the sensor case cap, fit the hooks of the sensor case into
portion A of the sensor case cap.
2. When reassembling the sensors, align the pins on the sensor case with the holes of
the sensors.
3. Connect the harness including the green wire to the black mark sensor (lower side).
4. Pass the media sensor harness between the harness guides.
5. Since connectors of the sensors are small, be careful not to break their pins.
Black Mark Sensor
(Lower side)
Green
Sensor Case
Sensor Guide
Media Sensor Harness
Feed Gap Sensor (LED)
(Number of pins: 2)
Pin
Front side of
the printer