Filter
Top Products
2. PRINTER SETUP
ENGLISH VERSION EO1-33028
2.3 Assembling the Accessories
E2- 3
2.3 Assembling the
Accessories
2.3.1 Assembling the Supply
Holder Frame
The following procedure outlines the steps required to assemble the
Supply Holder Frame and attach the frame to the B-852 printer in
preparation for loading the media.
1.
Assemble the Supply Holder Frame (L) and Supply Holder Frame (R)
to the Supply Holder Base using the two M-4X6 Wing Bolts supplied,
as shown below.
2.
Attach the assembled Supply Holder Frame to the rear of the B-852
printer by inserting the hooks of the Frame into the two slots in the
rear of the printer as shown in the figure below.
NOTE:
M
ake sure that the two small
f
langes at each end of the
Supply Holder Base fit into
the small rectangular holes a
t
the bottom of the Supply
H
older Frames before
tightening the Wing Bolts.
NOTE:
A
fter attaching the supply
holder frame to the printer,
make sure that it is assemble
d
f
irmly.
Supply Holder Base
Suppl
y
Holder Frame
(
L
)
Suppl
y
Holder Frame
(
R
)
Wing Bolt
Wing Bolt
Hook