Filter
Top Products
1. PRODUCT OVERVIEW
ENGLISH VERSION
EO1-33028
1.1 Introduction
E1- 1
1. PRODUCT OVERVIEW
1.1 Introduction
1.2 Features
1.3 Unpacking
Thank you for choosing the TEC B-852 series label/tag printer. This
Owner’s Manual contains from general set-up through how to confirm
the printer operation using a test print, and should be read carefully to
help gain maximum performance and life from your printer. For most
queries please refer to this manual and keep it safe for future reference.
Please contact your TOSHIBA TEC representative for further
information concerning this manual.
The B-852 printer has the following features:
• A 8.3 inch wide print head is installed in such a compact body that the
size of the printer body (except the Supply Holder Unit) is about 1/3
of the B-872 printer.
• The print head block which can be fully opened realizes great
operability.
• Various kinds of media can be used since the black mark sensors are
located above and under the media passage, respectively, and the
media sensors can be moved from the center to the left edge of the
media.
• When the optional interface board is installed, Web functions such as
remote maintenance and other advanced network functions are
available.
• Superior hardware, including the specially developed 11.8 dots/mm
(300 dots/inch) thermal print head which will allow very clear print at
a printing speed of 50.8 mm/sec. (2 inches/sec.) or 101.6 mm/sec. (4
inches/sec.).
• Besides the optional cutter module, there is also an optional PCMCIA
Interface Board, Expansion I/O Interface Board, PCL5 Interface
Board Kit, and the KB-80-QM Keyboard Unit.
Unpack the printer as per the Unpacking Instructions supplied with the
printer.
NOTES:
• Check for damage or
scratches on the printer.
However, please note that
TOSHIBA TEC shall have no
liability for any damage of
any kind sustained during
transportation of the product.
• Keep the cartons and pads for
future transportation of the
printer.