Filter
Top Products
4. ON LINE MODE
ENGLISH VERSION EO1-33028
4.4 Dump Mode
E4- 3
4.4 Dump Mode
In Dump mode, any characters sent from the host computer will be
printed. Received characters are expressed in hexadecimal values. This
allows the user to verify programming commands and debug the
program.
1.
The printer is turned on, standing by, or printing.
2.
Press the
[PAUSE]
key.
3.
During the Pause state, press and hold the
[RESTART]
key for 3
seconds or more. The display shows “<1> RESET”.
4.
Press the
[FEED]
key. The display shows “<2>PARAMETER SET”.
5.
Press the
[FEED]
key. The display shows “<3>ADJUST SET”.
6.
Press the
[FEED]
key. The display shows “<4>DUMP MODE”.
Press the
[PAUSE]
key to enter the Dump Mode.
7.
Select the receive buffer to be dumped with the
[FEED]
or
[RESTART]
key
8.
Press the
[PAUSE]
key to start printing. The printer prints the data in
the selected receive buffer.
9.
After completing the printing, the display returns to “<4>DUMP
MODE”.
10.
Reset the printer by turning the power off and on. The display
shows “ON LINE”.
21/,1(
!5(6(7
!3$5$0(7(56(7
3$86(
!$'-8676(7
%8))(556&
!'80302'(
!'80302'(
21/,1(
12:35,17,1*
[FEED]
[RESTART]
• RS-232C: RS-232C Receive Buffer
• CENTRO: Centronics Receive Buffer
• NETWORK: Network Interface Receive Buffer
CAUTION!
Please do not select
<2>PARAMETER SET and
<3>ADJUST SET modes.
They are selectable,
however, the printer may
malfunction if the values ar
e
not set correctly. For
details, please refer to your
nearest TOSHIBA TEC
service representative.
NOTE:
I
f an error occurs during the
receive buffer dump, the display
will show an error message and
the printer will stop printing.
Clear the error by pressing the
[PAUSE]
key and the display
will return to “<4>DUMP
M
ODE”. Printing will not
restart automatically.