Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33047
2.3 Loading the Media
E2- 7
2.3 Loading the Media
(Cont.)
Setting the Black Mark Sensor position
When using media with black marks, the Black Mark Sensor is used to
detect a print start position.
(1) Push the Upper Sensor Lever inside and open the Upper Sensor
Ass’y.
(2) Check the reverse side of the media for the black mark position.
(3) Slide the Lower Sensor Tab to move the Black Mark Sensor so that
it is in line with the centre of the black mark on the media.
( indicates the position of the Black Mark Sensor).
It may be easier to move the Lower Sensor Tab if you use a pen
inserting its tip into the pinhole of the tab.
(4) Lower the Upper Sensor Ass’y until the Upper Sensor Lever clicks
in position.
Lower Sensor
Tab
Black Mark
Sensor
NOTES:
1. Be sure to set the Black Mark
Sensor to detect the centre of the
black mark, otherwise a paper
jam or no paper error may
occur.
2. After adjusting the Black Mark
Sensor position, align the Upper
Feed Gap Sensor with the
Lower Feed Gap Sensor. This is
because a paper end is detected
by the Feed Gap Sensor.
Pinhole