Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33047
2.3 Loading the Media
E2-10
2.3 Loading the Media
(Cont.)
When the optional Cutter Module is fitted, the media is automatically cut.
Insert the leading edge of the media into the Media Outlet of the Cutter
Module.
13. Change the print head pressure according to the thickness of the
media to be used, by using the Head Position Lever.
Media type or thickness
Head Position
Lever
Label or Thin media
c
If a clear print cannot be obtained,
change the position to
d.
Move the levers
toward the front of
the printer.
Tag paper or Thick paper
d
If a clear print cannot be obtained,
change the position to
c.
Move the levers
toward the back of
the printer.
14. If the loaded media is direct thermal media (with a chemically
treated surface), the media loading procedure is now completed.
Close the Top Cover.
If the media is normal media, it is also necessary to load a ribbon.
Refer to Section 2.4 Loading the Ribbon.
Media
Cut mode
(
O
p
tion
)
CAUTION
!
1. When using a label stock, be
sure to cut the gaps. Cutting
labels will cause the glue to
stick to the cutter, which may
affect the cutter quality and
shorten the cutter life.
2. Use of tag paper which
thickness exceeds specified
value may affect the cutter
life. For the specification of
the media, refer to Section
7.1 Media.
The cutter is sharp, so care
must be taken not to injure your
fingers when handling the
cutter.
WARNING!
Head Position Lever
c
d
c
d
NOTES:
1. Be sure to set both Head
Position Levers in the same
direction. Failure to do this
may cause blurred printing.
2. Do not leave the Head Position
Levers positioned at the middle.
When closing the Top Cover,
they block the Print Head
Positioning Shaft, and the Top
Cover cannot be closed.
Print Head Positioning Shaft
Head Position Lever
Head Position Lever