Filter
Top Products
4. REPLACING THE IMPORTANT PARTS
EO18-33013
4.9 Installing the Optional Cutter
4-12
4. Remove the Push Button.
NOTE: Do not remove the Push Button for any purposes except for replacement. If the
Push Button is removed, be sure to fully insert it when reassembling.
5. Reassemble in the reverse procedures after replacing.
After attaching the Push Button PC Board, set the media on the printer, turn on the
power, and confirm that the media is fed when the Push Button is pressed.
4.9 Installing the Optional Cutter
1. Turn off the printer power.
2. Remove 7 screws to detach the Lower Cover. (Refer to Section 4.3.)
3. Insert Cutter IC (U14) on the Main PC Board.
4. Remove the Front Cover.
Cutter IC
Push Button
WARNING!
1. Be sure to turn OFF the power before removing the Cutter Cover.
2. Care must be taken not to injure your fingers by the cutter blade.