Filter
Top Products
4. REPLACING THE IMPORTANT PARTS
EO18-33013
4.4 Replacing the Motor Fixing Frame Assembly and Motor
4-8
5. Remove the 4 screws to detach the Sensor Lower Cover.
6. Remove the Motor Fixing Frame Assembly.
NOTE: When reassembling the Motor Fixing Frame Assembly, refer to Section 4.5 and insert
the shaft of the Label Guide Adjustment into Hole A.
7. Reassemble in the reverse procedures after replacing.
NOTES:
1. Be sure to hook the both ends of the spring into
the pin holes as shown in the figure below. Do
this to both springs.
2. Make sure that the Motor rotates smoothly by
turning it manually.
3. Apply FLOIL to the all gears of the Motor Fixing
Frame Assembly.
Sensor Lower Cover
T-3x6 Screw
T-3x6 Screw
Motor Fixing Frame Assembly
Hook Lever
Spring
Hook
Hook
A