Filter
Top Products
4. REPLACING THE IMPORTANT PARTS
EO18-33013
4.5 Replacing the Label Guide Adjustment Assembly
4-9
4.5 Replacing the Label Guide Adjustment Assembly
1. Rotate the Label Guide Adjust Knob to move the Label Guides to the center.
2. Remove the 7 screws to detach the Lower Cover. (Refer to Section 4.3.)
3. Loosen 4 screws and remove the Sensor Lower Cover. (Refer to Section 4.4.)
4. Remove Label Guide Adjustment Knob.
NOTE: If it is hard to remove the Label Guide Adjustment Knob, release the two hooks first.
Be careful not to damage the hooks.
5. Remove Label Guide Adjustment Assembly.
6. Reassemble in the reverse procedures after replacing. While reassembling, be sure
to apply FLOIL to the Screw Gear.
Label Guide
Adjustment Knob
Label Guide Adjustment Assembly
Label Guide
Label Guide
Adjust Knob
Hook
LUBRICATION
Screw Gear: FLOIL