Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33087
2.7 Loading the Media
E2- 9
2.7 Loading the Media
(Cont.)
6. Adjust the media sensor position and select a sensor type to be used.
(Refer to Section 2.9.1)
This printer is provided with a Black Mark Sensor which detects black
marks printed on the reverse side of the media, and a Feed Gap Sensor
which detects inter-label gaps.
As the Feed Gap Sensor position is fixed, it is not necessary to move it.
When using the Black Mark Sensor, align it with the center of a black
mark. Failure to do this disables the detection of black marks, resulting
in an error.
7. Pass the media between the Media Guides, and turn the Media Guide
Adjustment Dial in the arrow indicating direction to adjust the Media
Guides to the media width.
8. Push the Media Holders against the media roll to firmly hold it, then
slide the Media Holder Lock Switch to the Lock (▼) side.
Media Guide
NOTE:
B
e careful the Media Guides do
not squeeze the media. Doing
so bends the media, causing a
p
aper jam or feed failure.
Black Mark Sensor
NOTES:
1. The sensor type used in the last
print job has been selected. To
change the sensor type, refer to
Section 2.9.1 Media Sensor
Calibration.
2. The Feed Gap Sensor is
positioned 6.35 mm right from
the media centre.
3. The Black Mark Sensor is
movable in a range of media
width.
Feed Gap Sensor
Black Mark Sensor is movable
in the full range.
6.35mm
Media Guide
Adjustment Dial
Media Holder
Lock Switch