Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33087
2.8 Loading the Ribbon
E2-15
2.8 Loading the Ribbon
(Cont.)
3. Push up the Ribbon Access Cover by the portions indicated by
arrows A and fully open it supporting the Print Head Block.
4. Fit the Ribbon Take-up Roll to the Spring Guide Wheel and the Guide
Wheel in the same way as the Ribbon Supply Roll.
(1) Push the right side of the core of the Ribbon Take-up Roll against the
Spring Guide Wheel and fit the wheel into the core.
(2) Fit the left side of the core of the Ribbon Take-up Core to the Guide
Wheel, aligning the notch of the ribbon core with the protrusion of the
Guide Wheel.
5. Turn the Ribbon Rewind Gear to wind the ribbon leading film onto
the Ribbon Take-up Core until the ink ribbon covers the Print Head,
and remove any slack of the ribbon.
Ribbon Access
Cover
Print Head
Block
Guide Wheel
Spring Guide Wheel
(Take-up side)
Ribbon
Rewind Gear
NOTE: Ribbon Path
A
A
Ribbon
Take-up
Core
Ribbon Supply
Roll
Print Head