Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33087
2.9 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities
E2-19
2.9.2 Self Print Test and
Dump Mode (Cont.)
The test print contents should be changed by the following commands
and parameters:
PROGRAM VERSION: VX.XX XXXX --- Firmware version and checksum
TONE ADJUST: +XX ------------------------- Print tone fine adjustment value
FEED ADJUST: +XX.Xmm ------------------ Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm ----- Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm ---------- Back feed amount fine adjustment value
PARAMETER: [PC-850][0] ----------------- Character code selection and Font “0”
selection
[9600][8][1][NONE][2]--- Baud rate, Data length, Stop bit length,
Parity, and Transmission control of RS-
232C
[ON][AUTO][FEED][B0]----- Forward feed wait function, Control code,
Feed key function, and Euro code
X-COORDINTE ADJUST: +XX.Xmm ----- X-coordinate fine adjustment value
SENSOR SELECTION: TRANSMISSIVE- Sensor selection and sensitivity
SENSOR ADJ. VALUE:
TRANSMISSIVE[XX] REFLECTIVE[XX] -- Sensor setting value
PRINT SPEED: 5IPS--------------------------- Print Speed
FLASH ROM:4MB----------------------------- Flash ROM Capacity
SDRAM: 8MB----------------------------------- SDRAM Capacity
USER MEMORY: [X KB][0 KB]------------ User Memory Capacity
TTF AREA: [XXXKB][XXXKB]------------ True type font storage area, Main PC board
and optional memory card
EXT CHAR AREA: [XXXKB][XXXKB] -- Writable character storage area, Main PC
board and optional memory card
BASIC AREA: [XXXKB][XXXKB] -------- BASIC file storage area, Main PC board and
optional memory card
PC SAVE AREA: [XXXKB][XXXKB]----- PC save storage area, Main PC board and
optional memory card
INFORMATION: ------------------------------- Printed only when some information is
stored in the flash ROM
TOTAL FEED----------------------------------- Total feed distance
TOTAL PRINT: 0.00 km ---------------------- Total Print distance
TOTAL CUT: 0 --------------------------------- Total Cut Count
IP ADDRESS: 192.168.10.20-----------------
SUBNET MASK: 255.255.255.0-------------
GATEWAY: 0.0.0.0----------------------------
MAC ADDRESS: XX-XX-XX-XX-XX ----
DHCP: Disabled---------------------------------
DHCP CLIENT ID:
FFFFFFFFFFFFFFFFFFFF FFFFFFFFFFFF ----
SOCKET COMM.: Enabled-------------------
SOCKET COMM. PORT: 08000-------------
N
etwork setting values