Filter
Top Products
6-13
Replacing the battery pack
P
OWER
AND
P
OWER
-
U
P
M
ODES
Replacing the battery pack
When the battery pack reaches the end of its operating life you will need to
install a new one. If the Battery indicator flashes amber shortly after fully
recharging the battery, the battery pack needs to be replaced.
You might also replace a discharged battery pack with a charged spare when you
are operating your computer away from an AC power source. This section
explains how to remove and install battery packs.
Removing the battery pack
To replace a discharged battery pack, follow the steps below.
CAUTIONS: 1. When handling battery pack, be careful not to short cir-
cuit the terminals. Also do not drop, hit or otherwise
apply impact; do not scratch or break the casing and do
not twist or bend the battery pack.
2. Do not remove the battery pack while the computer is in
Standby mood. Data is stored in RAM, so if the computter
loses power it will be lose.
3. In Hibernation mode, data will be lose if you remove the
battery or disconnect the AC adaptor before thesave is
completed. Wait for the Fixed HDD/ODD indicator to go
out.
1. Save your work.
2. Turn the computerķs power off. Make sure the Power indicator is off.
3. Remove all cables connected to the computer.
4. Turn the computer upside down with the back of the computer facing you.
5. Slide the battery pack locking latch toward the unlock position.