Filter
Top Products
2.10 Optical Drive Troubleshooting 2 Troubleshooting Procedures
Satellite M60/M65 Series Maintenance Manual
[CONFIDENTIAL]
2-29
Procedure 5 Connection check and replacement check
The optical drive connects to the system board. The drive may be disconnected, or the drive or
system board may be damaged. Disassemble the computer following the steps described in
Chapter 4, Replacement Procedures, and perform the following checks:
Check 1 Make sure the drive is firmly connected to the system board. If the connection is
good and there is still an error, go to Check 2.
Check 2 The drive or drive cable may be defective or damaged. Replace each with a new one
following the steps in Chapter 4, Replacement Procedures. If the drive is still not
functioning properly, perform Check 3.
Check 3 The system board may be damaged. Replace it with new one following the
instructions in Chapter 4, Replacement Procedures.