Filter
Top Products
User’s Manual 4-7
Operating Basics
O
PERATING
B
ASICS
1. Click Start, Point to All Programs, point to Protector Suite QL and
click User Enrollment.
2. The User's Password screen is displayed. Ensure the same Windows
logon username is displayed before entering a password into the Enter
your Password field. Click Next.
3. Click Next.
4. The Hints for fingerprint enrollment screen is displayed.
Confirm the message and that there is a checkmark in Run interactive
tutorial, and click Next.
5. The Correct swipe Procedure screen is displayed. Confirm the message and
click Next.
6. The Scanning Practice screen is displayed.
You can practice swiping your finger. When you have finished practicing
swiping your finger, click Next.
7. The User’s Fingers screen is displayed. Based on the illustration, select
the finger to be recognized, and then click Next.
8. The Capture Fingerprint screen is displayed. Follow the onscreen
instructions and use the same finger you have selected under Choose Fin-
ger to swipe three times to allow the sensor to read the fingerprint. The fin-
gerprint will be shown in green if properly read, or in red if the reading is
abnormal.
9. In case of finger injury or authentication failure, it is recommended that
another fingerprint also be enrolled. The following message will be dis-
played: "It is recommended that you enroll at least two fingers. Would you
like to enroll another finger now?" Click Yes and repeat steps 7, 8 and 9
with another finger. If any of the previously enrolled fingerprints is selected
again, the latest information will be enrolled and previous information over-
written.
10. The Advanced Security screen is displayed.Select whether to enable the
security function, and click Next.
11. The Finalization screen is displayed. Click Finish. This completes the
fingerprint registration process.
You can also start User Enrollment Wizard using the following
method.
❑ Click the icon in the Task Bar.
❑ Swipe your finger across the Fingerprint Sensor.