Toshiba TDPTW300 Projector User Manual


 
71
Operations
70
Using the Wireless Utility (Continued)
5
Select the projector to be
transmitted.
The IDs of projectors accessible for
communication will be listed. (If projector name
has been set up already, it is shown instead of
the MAC address.) Select the checkbox of the
projector to be transmitted to from this list. Then
icon
is displayed on the projector’s screen
for few seconds.
It is possible to select up-to four projectors.
6
Click on the button.
The selected file’s image is displayed by the projector.
Note
Only one file can be sent at a time. To send another file, repeat steps
4
and
6
.
Easy Connect utility
This feature allows users to easily connect the projector to a computer over wireless
networks, without making network settings via Wireless Utility.
Launch the Wireless utility software application and click the Tool button (icon) to bring up
the Wireless LAN utility dialog box. Select a desired connection mode in this dialog box.
How to set up a simple 1:1 connection
Setting on the projector
1
Turn the projector power on.
2
Insert the supplied wireless LAN PC card to the PC card slot.
3
Switch the input to Wireless/Card.
4
Press the button on the projector control panel.
Setting on the computer
1
Launch the Wireless Utility software
application.
When the Wireless Utility launches, the
Screen Image transmission mode window
appears on the computer screen.
2
Click the Tool button .
The Wireless LAN Setting Utility dialog box
appears.
3
Select Simple 1:1 connection then
click OK.
The connection starts up.
When a connection confirmation message
appears, proceed as instructed in the
message.
4
The projector name of the connected
projector or the MAC address of the
wireless LAN PC card is displayed.
Notes
This operation is allowed only when the Transmission mode is set to Ad hoc in the
projector network settings.
The operation procedure of the projector setting and the computer setting can be
altered without affecting the connection setup, assuming the operation on each side
is complete within 60 seconds.
How to connect USB memory
Set up wireless LAN using a commercial USB memory. See [p.57> for available USB
memories.
Copying the computer settings to the projector
Setting on the computer
1
Plug the USB memory into the
computer.
2
Click the button of the Wireless
Utility to bring up the Wireless LAN
Utility dialog box. Select Connect
USB memory and click OK.
The dialog box for USB memory connection
appears.
3
Select how to create the setting information then click OK.
• Copies the settings information of the current PC.
• Creates the settings information manually.
The setting information is saved to the USB memory.