Filter
Top Products
10 TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive
CD-ROM
DRIVE
Host Computer
I/F Card
Terminator
SCSI Cable
CD-ROM
DRIVE
Host Computer
I/F Card
Terminator
SCSI Cable
Interface
Connector
External Terminator
(see notes 1 & 3)
Interface Connector
CD-ROM
DRIVE
#2
CD-ROM
DRIVE
#N
(N < 7)
Install Terminator Jumper
only on the last drive of BUS
(see note 1)
Host Computer
I/F Card
Terminator
SCSI Cable
TXM6401F1/XM-6401B CONNECTION (ONE DRIVE)
TXM6401F1/XM-6401B DAISY-CHAIN CONNECTION (MULTIPLE DRIVES)
If connecting more
than three SCSI
devices, you need to
use a custom built
SCSI Interface Cable.
XM-6401B
INTERNAL DRIVE(S)
TXM6401F1
EXTERNAL DRIVE(S)
CD-ROM
DRIVE
#1
SCSI Interface Connector from
host computer
CD-ROM
DRIVE
#2
CD-ROM
DRIVE
#N
(N < 7)
Install External
Terminator on last drive on BUS
(see notes 1 & 3)
CD-ROM
DRIVE
#1
Notes:
1. Terminator jumper must be jumpered when CD-ROM is the last or only device on the SCSI BUS.
2. Terminator jumper should be removed when CD is in a "daisy-chain" and is NOT the last drive.
3. The TXM6401F1 uses an external terminator which must be attached to the last drive of a "daisy
chain". The external terminator is an optional item.
Interface
Connector
X
M
6
4
0
1
B
T
X
M
6
4
0
1
F
1
(see note 2)
(see note 2)
(see note 2)
(see note 2)
(see note 1)
Daisy-Chaining - If the CD-ROM you are installing is one of two or
more SCSI devices you have connected to your system, you will need
to use a custom built SCSI interface cable. Remember that the termi-
nator jumper on the CD-ROM drive must have the jumper installed
when the drive is the last device in the chain.