Filter
Top Products
Replacement Procedures
Figure 4-14-3 Disconnect the touch pad flat cable/Fingerprint cable
Installing Top Cover assembly
The following describes the procedure for installing the top cover assembly.
1. Install the top cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between top cover assembly and base
assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the top cover assembly with following screws from the front of computer.
M2.5x6.5 Flat BIND screws x7
M2.5x3.0 Flat BIND screws x2
4. Secure the top cover assembly with the following screws from the back and bottom
of computer.
M2.52.0 FLAT BIND screw x5 M2.56.5 FLAT BIND screw x11
M2.58.0 FLAT BIND screw x6 M2.54.0 FLAT BIND screw x2
M2.53.0 FLAT BIND screw x1
5. Free the cable from cable-drain when through the antenna cable to PCB hole.
Qosmio X500 Maintenance Manual (960-Q08)
4-44