Filter
Top Products
Replacement Procedures
4.16 USB Board
The following describes for removing the USB board (See Figure 4-16-1).
Removing the USB Board
1. Pull out the USB cable, Audio cable, from USB board connector.
2. Loose the below screws and then incline pull out USB board.
M2.5x6.5 FLAT BIND screw x2
Figure 4-16-1 Remove the USB board
Installing the USB Board
The following describes the procedure for installing the USB board.
1. Insert the USB board into base case and connect USB board cable, Modem cable
2. Fix the below screws
M2.5x6.5 FLAT BIND screw x2
NOTE: Be careful not to catch the cables between top cover assembly and base
assembly.
Qosmio X500 Maintenance Manual (960-Q08)
4-48