Filter
Top Products
81
The logging local flash command is used to configure the level and the status
of the log file input.To restore to the default configuration, please use no
logging local flash command. The log file indicates the flash sector for saving
system log. The inforamtion in the log file will not be lost after the switch is
restarted and can be got by the show logging flash
command.
Syntax
logging local flash {level} [ disable | enable ]
no logging local flash
Parameter
level ——Severity level of the log information output to each channel. There are
8 severity levels marked with values 0-7. The smaller value has the higher
priority. Only the log with the same or smaller severity level value will be output.
By default, it is 4 indicating that the log information marked with 0~4 will be
saved in the log buffer.
disable | enable ——Disable or enable the log file. By default, it is enabled.
Command Mode
Global Configuration Mode
Example
Enable the log file function and set the severity as 7:
TP-LINK(config)# logging local flash 7
logging clear
Description
The logging clear command is used to clear the information in the log buffer
and log file.
Syntax
logging clear [ buffer | flash ]
Parameter
buffer | flash —The output channels: buffer and flash. Clear the information of
the two channels, by default.
Command Mode
Global Configuration Mode