Filter
Top Products
© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPL-306E / TPL-306E2K
4
Power Saving: The device will automatically reduce power usage when the connected
devices via Ethernet are powered off, unplugged or inactive for more than 3
minutes.
Erp (EuP) Operation: Standby Mode
Disconnect the Ethernet cables from the device Ethernet ports, and after 3 minutes,
the device will enter standby mode. The Power (PWR) LED will flash every 15
seconds to indicate that the device is currently in standby mode.
To return to active mode, reconnect the Ethernet cables to the device Ethernet
ports, and the device will re-enter active mode.
Application Diagram
A router is already installed in the room where the xDSL/Cable modem (typically
supplied by your ISP “Internet Service Provider”) is located in order to physically connect
an Ethernet cable (also called network cable) from the router WAN port to the modem
network port which connects to the Internet. A second Powerline adapter is plugged
into a wall power outlet in another room in order to extend the network connectivity to
the network devices in that room. The Ethernet port of the second Powerline adapter is
then connected to a network enabled TV or other network enabled media device in
order to extend connectivity to these devices allowing access to your network and to
the Internet through the electrical system.