Tripp Lite 3U Rackmount Power Supply User Manual


 
Manual del propietario
1111 W. 35th Street Chicago, IL 60609 USA
Soporte al cliente: (773) 869-1234 • www.tripplite.com
Instrucciones de seguridad importantes
14
Montaje
15
Instalación rápida
16
Operación básica
19
Almacenamiento y servicio
23
English
Copyright ©2005 Tripp Lite. Todos los derechos reservados. SmartPro
®
es una marca comercial registrada de Tripp Lite.
SmartPro
®
3U Rackmount
(5000VA)
Sistemas de UPS Inteligentes e Interactivos en Línea
• 230V Entrada/Salida
• Opciones de Operación Extendidas
No conveniente para los usos móviles.
1
Reemplazo de batería
24
Français
25
Instalación opcional
17
Póññêè
é
37
12
Battery Replacement
The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number
can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product,
always refer to the series number. The series number should not be confused with the marking name or model number of the product.
This product designed and engineered in the USA.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
Battery replacement should be performed only by authorized service personnel using the same num-
ber and type of batteries (sealed Lead-Acid). Under normal conditions, the original batteries in your
UPS will last many years. See Safety section before replacing batteries. The batteries are designed
for hot-swap replacement (i.e. leaving the UPS in ON mode), but some qualified service personnel
may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.
Procedure
Remove Front Panel and Battery Holding Plate
Disconnect Batteries
Remove/Dispose of Batteries
Add Batteries
Connect Batteries
Attach connectors: black-to-black and red-to-red.
Replace
Front Panel
WARNING!
Batteries can present a risk of electrical shock and burn
from high short-circuit current resulting in serious
injury or death. Battery terminals are in close proximity
to UPS cabinet and special care must be taken to avoid
shorting the batteries including not touching metal
cabinet and battery terminals simultaneously.
6
5
4
3
2
1
S
MART
P
RO
®
UPS
1
6
2
5
3
4
200505103--Smart 230V Owners Manual.qxd 5/24/2005 11:29 AM Page 12